Showing 101 to 120 out of 120
This relic belt plate consists of the center part of the plate only. The entire border as well as both posts and tongue on the reverse are gone. The face has a dark and scaly appearance with most of… (1181-20). Learn More »
Black leather belt meas. approx. 1.75 inches wide with a line of stitching outlining each edge. The leather surface shows light to moderate surface finish loss from rubbing and use over the years. The… (2022-957). Learn More »
The face is in unissued condition and showing a lot of the original finish. Face is clean but for a few oxidation spots. Top edge has several very slight dimples. The reverse has 100% of the lead fill… (2022-741). Learn More »
Item is in good condition. Brass face with typical eagle stamping. Light wear on the edges. Back has most of its lead fill with moderate pitting. The wire loops are missing. This plate is for use on… (1163-78). Learn More »
The leather belt is 1.75” wide and approximately 50” long overall. Belt is made of bridle leather with a brass keeper sewn and riveted on one end and a brass adjustment hook riveted to the… (490-2824). Learn More »
This is a very nice early, American-made, set of infantry or militia accoutrements. Set consists of a cartridge box on a waist belt with a sheet brass buckle and a bayonet with scabbard and belt frog… (401-45). Learn More »
This is an excellent example of O’Donnell and Campbell Plate #700 in American Military Belt Plates. It is complete with its keeper and is on its original belt. The detail of the plate good enough… (490-2626). Learn More »
This is the M1839 oval U.S. belt plate made for the narrow 1.5-inch U.S infantry waist belts of the Mexican War period. Like the Civil War versions, these are made of rolled stamped brass with a lead… (766-1543). Learn More »
The two-piece CS plate was widely used on sword belts. The quality of the casting and finish work depended on the time, resources and talent of the different makers. This one shows nice detailing to… (1126-02B). Learn More »
$750.00
ON HOLD
The belt plate and buckle pictured here is from mid Civil War, 1862-1864. The eagle plate is an 1851 pattern prevalent in late war enlistees. The design was introduced in 1851 with… (172-3107). Learn More »
Plate is sand cast brass with nice dark patina overall and a very nice “C.S.A.” at center. Reverse has all three brass hooks. A close examination reveals some lumps and bumps to the casting as… (33-250). Learn More »
The flaming bomb was associated in the U.S. military with the Ordnance Department, but comes from a long tradition of the flaming grenade being associated with picked troops detailed to get close… (410-542). Learn More »
The face of this plate is mostly clean with a good strong “US” stamping. Lower right edge has two small dings. Face also has some scattered spots of oxidation. Reverse has the single arrow hook… (1110-25). Learn More »
Plate meas. approx. 2.25 x 3.50. It is made of slightly convex sheet brass with clipped corners. A white metal number “1” is attached by iron loops passing through the brass and being held by thin… (1110-30). Learn More »
Plate meas. approx. 2.25 x 3.50. It is made of slightly convex sheet brass with clipped corners. Reverse has a thin bar along one edge for attaching to a belt and a narrow tongue. Item has some light… (1110-27). Learn More »
Face has a nice even dark patina with a good strong “US” stamping. Face is free from any major dings or dents but does have scattered light brown spotting from ground action. Reverse has 99% of… (1000-1211). Learn More »
Plate has a dark underlying patina with scattered lighter spotting across the face. This was caused by ground action. Face is free of any major dings or dents. Reverse has 100% of the lead fill with… (1000-1210). Learn More »
Presented here is an excavated “Volunteer Militia of Maine” oval waist belt plate that was issued to the State’s volunteer infantrymen early in the Civil War. Maine formally organized its… (1000-1541). Learn More »
This Civil War Ohio Volunteer Militia Enlisted Infantry belt plate, is in good excavated condition. This early war belt plate measures 52 mm x 75 mm and is constructed from die-struck rolled sheet… (1000-1540). Learn More »
This US breast plate features the spread-winged eagle design. It was recovered from the greater Richmond area. Plate has a darkened patina. Edge of plate has some slight nicks. Reverse of plate still… (883-111). Learn More »
Showing 101 to 120 out of 120
Historical Firearms Stolen From The National Civil War Museum In Harrisburg, Pa »
Theft From Gravesite Of Gen. John Reynolds »
Cavalry Carbine Sling Swivel »
Fine Condition Brass Infantry Bugle Insignia »
Commercial caps were simply those purchased privately rather the issued by the government. They might more or less closely follow contract patterns with the purchaser able to suit his taste and wallet, though an enlisted man, seeking something nicer… (1052-139). Learn More »