Showing 101 to 111 out of 111
This very large flask has to have been for shotguns. Constructed with a copper body, with brass top and spout. Measures approximately 11” tall x 5” at widest point. Unadorned body. Thumb tab and… (172-5639). Learn More »
This flask is for early pocket model revolvers. Constructed with a copper body, with brass top and spout. Measures approximately 6” tall x 2.75” at widest point. Both sides are plain. Thumb tab… (172-5638). Learn More »
Fabricated by Ludlow Brothers of Birmingham, England. Nice display in a 8.25” x 12.25” Riker case. Photocopy of an original wrapper at top with info sheet below, and then the cartridge at the… (M24055). Learn More »
Iron bullet mold measures approximately 7 ½” long. Two halves pinned with rivet and has floating sprue cutter. Iron is pitted but not badly; could be “dug” or out of a barn. Still opens and… (1117-238). Learn More »
Scissor-type mold made of brass. Casts a .44 caliber “picket” or “sugarloaf” style of bullet with rounded base. Measures 6 ½” overall. Brass has a blotchy, dark patina. … (1117-234). Learn More »
This is a “pulp bag” of percussion caps as manufactured at the Royal Laboratory at Woolwich, England. Each pack was to contain 15 copper percussion caps. Packages are full of caps and twisted… (M25673). Learn More »
Dark worn paper cartridge with conical bullet in nose. The body of the cartridge is complete but the paper looks weary. The tail has separated from the cartridge due to age and weakness of the… (169-280). Learn More »
$200.00
Originally $250.00
Fabricated by Ludlow Brothers of Birmingham, England. Nice display in a 8.25” x 12.25” Riker case. Photocopy of an original wrapper at top with info sheet below, and then the cartridge at the… (M24051). Learn More »
Pack has the original brown wrapper and label but string is replacement. Top is cut and held in place by string. Lid can be lifted to view cartridges. Light blue label with black printing reads “10… (172-3989). Learn More »
This tool is to be attached to the threaded end of the ramrod and used to clean debris out of the barrel. Good condition, light surface rust. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ THIS ITEM, AS WITH… (M24178). Learn More »
This tool is to be attached to the threaded end of the ramrod and used to clean debris out of the barrel. Good condition, light surface rust. ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ THIS ITEM, AS WITH… (M24177). Learn More »
Showing 101 to 111 out of 111
Historical Firearms Stolen From The National Civil War Museum In Harrisburg, Pa »
Theft From Gravesite Of Gen. John Reynolds »
Selection Of Unframed Prints By Don Troiani »
Fine Condition Brass Infantry Bugle Insignia »
British Imported, Confederate Used Bayonet »
Scarce New Model 1865 Sharps Still In Percussion Near Factory New »
The relationship between the two men pictured is not known but no doubt they are either brothers or the same man at different points in his life. The left side ambrotype is of a seated man sporting a closely trimmed beard and mustache wearing a dark… (1138-1975). Learn More »
May 16 - 18: N-SSA Spring Nationals, Fort Shenandoah, Winchester, VA Learn More »