Firearms

Showing 201 to 220 out of 249


CONFEDERATE ORDNANCE CLEANED AND REPAIRED (C&R) US M1861 BRIDESBURG DATED 1863

CONFEDERATE ORDNANCE CLEANED AND REPAIRED (C&R) US M1861 BRIDESBURG DATED 1863

This M1861 rifle musket recently came out of North Carolina. Stock markings and at least one barrel band show it to have been captured and reissued by Confederate ordnance authorities. Some minor… (490-2428). Learn More »

$2,600.00
Originally $3,250.00

LEATHER SADDLE HOLSTERS FOR THE COLT DRAGOON REVOLVER

LEATHER SADDLE HOLSTERS FOR THE COLT DRAGOON REVOLVER

Black leather saddle holsters for the large and heavy Colt Dragoon pistols. Overall, the leather is in good condition but the yoke between the holsters shows heavy surface finish loss. Each side of… (490-2779). Learn More »

EARLY POWDER MEASURE FOR PENNSYLVANIA/KENTUCKY RIFLES

EARLY POWDER MEASURE FOR PENNSYLVANIA/KENTUCKY RIFLES

Early hand-made powder measure for long hunting rifles. Measures 4.25" long overall with the tube being 4" long by 3/8" in diameter.  A nice accessory for a long rifle. [jet]… (490-2896). Learn More »

“SLIM JIM” HOLSTER FOR REVOLVER

“SLIM JIM” HOLSTER FOR REVOLVER

This is a nice brown leather “Slim Jim” holster for M1851 and M1861 Colt Navy conversions. Holster body is one piece sewn down the back seam. Stitching remains strong and unbroken. Geometric… (1142-128). Learn More »

WOODEN CRATE FOR SHARPS CARBINES DATED AUGUST 1876

WOODEN CRATE FOR SHARPS CARBINES DATED AUGUST 1876

Wooden shipping crate for 10 sharps carbines. Crate is missing the lid but is marked on one end with a clear date of “AUGUST 1876.” The same edge has some faint markings that look to read “10… (172-5755). Learn More »

.50 CALIBER MAYNARD CARTRIDGES

.50 CALIBER MAYNARD CARTRIDGES

Priced to Sell – These are non-excavated cartridges for the .50 caliber Maynard carbine.  Lead bullet with flat nose and a single groove in a brass case with large disc soldered to the bottom. A… (490-768). Learn More »

CONFEDERATE ORDNANCE “CAPTURED AND COLLECTED” BRIDESBURG RIFLE MUSKET

CONFEDERATE ORDNANCE “CAPTURED AND COLLECTED” BRIDESBURG RIFLE MUSKET

Some 200,000 thousand firearms captured or collected by CS Ordnance teams and civilians, along with perhaps another 50,000 turned in by CS units, went through the cleaning and/or repair… (1164-13). Learn More »

$3,250.00
ON HOLD

SCARCE NEW MODEL 1865 SHARPS STILL IN PERCUSSION NEAR FACTORY NEW

SCARCE NEW MODEL 1865 SHARPS STILL IN PERCUSSION NEAR FACTORY NEW

There are no appreciable differences between the NM1863 and NM1865 Sharps other than the stamped model designation by the company, and its occasional absence, which some have speculated was due to… (490-2531). Learn More »

SHARPS MODEL 1855 BRITISH CONTRACT CARBINE WITH RACK NUMBERS

SHARPS MODEL 1855 BRITISH CONTRACT CARBINE WITH RACK NUMBERS

Sharps Model 1855 arms are scarce. Just under 1,000 went to the American market: 600 US Army carbines (on two contracts of 400 and 200 guns each,) about 350 Navy rifles and carbines, and a dozen or… (490-2664). Learn More »

.45 CALIBER IRON PISTOL BALL MOLD & BARREL TOOL

.45 CALIBER IRON PISTOL BALL MOLD & BARREL TOOL

Iron scissor-type mold to cast a lead round ball for revolvers.  Measures approximately 3.5” long overall. Single cavity mold with spout. Sprue cutter is formed between the two handles. Cavity… (1164-46). Learn More »

CLASSIC PRUSSIAN POTSDAM MODEL 1809 PERCUSSION MUSKET

CLASSIC PRUSSIAN POTSDAM MODEL 1809 PERCUSSION MUSKET

This original German longarm is a .72 caliber, Potsdam Model 1809 smoothbore musket in good condition. Musket measures a total length of almost 56.25” with a 41.25” long barrel and has been… (172-5783). Learn More »

VERY FINE ORIGINAL, FIRST TYPE, TWO-TRIGGER FRANK WESSON RIFLE

VERY FINE ORIGINAL, FIRST TYPE, TWO-TRIGGER FRANK WESSON RIFLE

Here is an original, seldom-seen Frank Wesson single-shot breechloader in excellent condition, one of the best that we have handled. This 1st Type, twin-trigger, .44 caliber rimfire, Wesson rifle made… (779-09). Learn More »

MODEL 1861 RIFLE MUSKET, BY REMINGTON, DATED 1865

MODEL 1861 RIFLE MUSKET, BY REMINGTON, DATED 1865

This is a Model 1861, .58 caliber, percussion rifle musket in good condition. Produced by E. Remington & Sons, Ilion, New York. Remington produced 40,000 rifles from 1864 to 1866. All gun metal on… (172-5729). Learn More »

VERY LARGE POWDER FLASK BY J. DIXON & SONS, SHEFFIELD

VERY LARGE POWDER FLASK BY J. DIXON & SONS, SHEFFIELD

This very large flask has to have been for shotguns. Constructed with a copper body, with brass top and spout. Measures approximately 11” tall x 5” at widest point. Unadorned body. Thumb tab and… (172-5639). Learn More »

POWDER FLASK FOR REVOLVERS

POWDER FLASK FOR REVOLVERS

This flask is for early pocket model revolvers. Constructed with a copper body, with brass top and spout. Measures approximately 6” tall x 2.75” at widest point. Both sides are plain. Thumb tab… (172-5638). Learn More »

CIVIL WAR FLAP HOLSTER FOR M1849 POCKET MODEL REVOLVER

CIVIL WAR FLAP HOLSTER FOR M1849 POCKET MODEL REVOLVER

This is a black leather holster made for revolvers. The leather still shows the “profile” of a revolver cylinder and barrel. A .31 caliber “pocket” model with long barrel fits into this… (172-5636). Learn More »

BLUED SMITH & WESSON NO. 2 ARMY REVOLVER

BLUED SMITH & WESSON NO. 2 ARMY REVOLVER

This is a Smith & Wesson, No. 2, Old Model Army Revolver. It is a .32 caliber, six-shot revolver with a 5” barrel, rosewood handles. Post-Civil War serial number 60737. Production began in 1861,… (1000-452). Learn More »

ARTILLERY VENT PUNCH FOR 10-INCH GUN – WATERVLIET ARSENAL

ARTILLERY VENT PUNCH FOR 10-INCH GUN – WATERVLIET ARSENAL

This is a tool for clearing the vent of any obstructions. It has an octagonal head with a hole in the center, and a 17” wire brazed to it. The wire comes to a point at the end. The flat head is… (1117-46). Learn More »

.577 CALIBER ENGLISH ENFIELD PATTERN CARTRIDGE

.577 CALIBER ENGLISH ENFIELD PATTERN CARTRIDGE

Fabricated by Ludlow Brothers of Birmingham, England. Nice display in a 8.25” x 12.25” Riker case. Photocopy of an original wrapper at top with info sheet below, and then the cartridge at the… (M24055). Learn More »

RELIC M1873 MAYNARD BULLET MOLD

RELIC M1873 MAYNARD BULLET MOLD

Iron bullet mold measures approximately 7 ½” long. Two halves pinned with rivet and has floating sprue cutter. Iron is pitted but not badly; could be “dug” or out of a barn. Still opens and… (1117-238). Learn More »


Showing 201 to 220 out of 249

featured item

AMES CIVIL WAR PRESENTATION SWORD AND POSTWAR PRESENTATION SWORD TO THE SAME NEW HAMPSHIRE OFFICER, WITH HIS COPY OF REGIMENTAL HISTORY – DANIEL J. FLANDERS

This group consists of two presentation Ames U.S. Model 1850 officer’s swords, one a Foot Officer pattern, with its original metal scabbard rather than leather, and the other a Staff and Field pattern, with the conventional metal pattern regulation… (2022-1207). Learn More »

Upcoming Events

27
Feb
Instagram