Showing 41 to 60 out of 122
Single cavity conical bullet mold to cast bullet for Smith and Gallager carbines. Iron mold halves connected with hinge pin. The iron swivel sprue cutter that was attached at the top is broken at the… (2-681). Learn More »
Iron, two cavity bullet mold for the .28 caliber hand guns. This has two iron halves joined with a hinge pin at the end, no sprue cutter. Has cavities for both conical and round ball. Measures 4.5”… (2-679). Learn More »
Iron, two cavity bullet mold for the .31 caliber Colt Pocket revolvers. It casts one round ball and one elongated bullet. Sprue cutter is attached to the top at the hinge pin and is clearly marked… (286-1355). Learn More »
Here is a round pasteboard box of primed cases for a 4mm Flobert pistol. Printed label on lid, printed red “tape” around side. Empty cases have “KC” headstamp. Good condition, but unknown… (172-4106). Learn More »
$100.00
Originally $125.00
This is a nice, untouched example of the Batty “Peace Flask” with a great un-messed with patina, good seams, good definition to the raised motifs with just a slight push at lower center of either… (632-101). Learn More »
This is a non-excavated model 1866 musket tool made from surplus M1855 combination tool. Three screw driver blades with the cone wrench cut off and two “spanner” pins cut in place. This spanner… (1268-189). Learn More »
This is a self-contained and primed copper cartridge with flat-nosed lead bullet. The copper case has been cleaned. These were centerfire cartridges where the primer was held internally, seated on an… (1212-198). Learn More »
Offered here is a scarce signal flare cartridge. Measures 2.75” long overall and 1” in diameter. White and green wrapper. Excellent condition. The signals prepared in the form of these cartridges,… (1268-197). Learn More »
$495.00
ON HOLD
This H-shaped, stamped belt plate was adopted by the U.S. Army in 1886 and used on what is sometimes called the “loose-loop” belt, which has woven cartridge loops. This clean blue belt and brass… (1216-219). Learn More »
This a small, very pretty York County powder horn in about excellent condition, with nicely turned spout matching the rich brown color of the upper portion of the horn that smoothly transitions into… (490-6906). Learn More »
This is a York County style powder horn made with a screw tip that is now missing, but with the upper portion of the spout clearly showing remnants of the threads that secured it. The form is… (490-6905). Learn More »
$295.00
ON HOLD
This is an early, classically York County style powder horn with two incised lines running around the top edge of the lathe-turned, convex base plug mirroring the two parallel incised lines along the… (490-6904). Learn More »
Dr. Edward Maynard held patent #22,565 dated January 11, 1859. By this patent, cartridge cases for the Maynard carbine were made of drawn brass to form a tube with a closed end. A brass disk was… (1212-186). Learn More »
This is a two-piece, scissor-type bullet mold made of brass. The two halves are held together with an iron pin. One arm is marked with a “2”. The mold measures 7.25” long overall. Brass exhibits… (1211-256). Learn More »
This fired brass shell casing was kept as a memento from the funeral of the highest-ranking U.S. officer killed in action in the Spanish-American War and comes with a period pencil note reading:… (1240-14). Learn More »
This is a .44 caliber revolver cartridge by Johnston & Dow of New York in excellent condition. Johnston & Dow received patent #33,393, #34,061, and #35,687 dated October 1, 1861, January 7,… (2024-1287). Learn More »
Very large iron hinge-type mold to cast 26 lead round balls. Twelve cavities on top and twelve on the bottom. Each side is complete with its own funnel/sprue cutter. Cavities measure approximately… (236-1007). Learn More »
Plain unfinished tin with label; measures approximately 1” tall x 1.5” in diameter. The body of the container has very nice tin finish with no rust. Lid has green paper label that reads “D [_]… (490-6899). Learn More »
$295.00
ON HOLD
This is an adjustable powder measure about 3 ½ inches long overall, made of brass, fitted with a small steel heart-shaped or winged thumbscrew at the bottom to adjust the interior rod fitted with a… (2024-160). Learn More »
Offered here is a very fine condition japanned tin filled with 100 “bulleted breech caps.” A printed paper label on the lid reads, “100 Superior BULLETED BREECH CAPS. / W. & C. ELEY,… (2024-125). Learn More »
Showing 41 to 60 out of 122
Historical Firearms Stolen From The National Civil War Museum In Harrisburg, Pa »
Theft From Gravesite Of Gen. John Reynolds »
Selection Of Unframed Prints By Don Troiani »
Fine Condition Brass Infantry Bugle Insignia »
Large English Bowie Knife With Sheath 1870’S – 1880’S »
Imported (Clauberg) Us Model 1860 Light Cavalry Officer's Saber »
Offered here is a wonderful lot of nine mounted photographs recorded around Fort Morgan following the Battle of Mobile Bay. All the photographs are pasted to plain card-stock mounts, each measuring 9.5” x 7.75”. Each mount features printed… (2025-1889). Learn More »